[article]
| Titre : |
Characteristics of nFOG, an aerosol-based wet thin film coating technique |
| Type de document : |
texte imprimé |
| Auteurs : |
Juha Harra, Auteur ; Mikko Tuominen, Auteur ; Paxton Juuti, Auteur ; Jenny Rissler, Auteur ; Heli Koivuluoto, Auteur ; Janne Haapanen, Auteur ; Henna Niemelä-Anttonen, Auteur ; Christian Stenroos, Auteur ; Hannu Teisala, Auteur ; Johanna Lahti, Auteur ; Jurkka Kuusipalo, Auteur ; Petri Vuoristo, Auteur ; Jyrki M. Mäkelä, Auteur |
| Année de publication : |
2018 |
| Article en page(s) : |
p. 623-632 |
| Note générale : |
Bibliogr. |
| Langues : |
Américain (ame) |
| Catégories : |
Aérosols
Polymères
Système de pulvérisation (technologie)
Taille des gouttelettes
|
| Index. décimale : |
667.9 Revêtements et enduits |
| Résumé : |
An atmospheric pressure aerosol-based wet thin film coating technique called the nFOG is characterized and applied in polymer film coatings. In the nFOG, a fog of droplets is formed by two air-assist atomizers oriented toward each other inside a deposition chamber. The droplets settle gravitationally and deposit on a substrate, forming a wet film. In this study, the continuous deposition mode of the nFOG is explored. We determined the size distribution of water droplets inside the chamber in a wide side range of 0.1–100 µm and on the substrate using aerosol measurement instruments and optical microscopy, respectively. The droplet size distribution was found to be bimodal with droplets of approximately 30–50 µm contributing the most to the mass of the formed wet film. The complementary measurement methods allow us to estimate the role of different droplet deposition mechanisms. The obtained results suggest that the deposition velocity of the droplets is lower than the calculated terminal settling velocity, likely due to the flow fields inside the chamber. Furthermore, the mass flux of the droplets onto the substrate is determined to be in the order of 1 g/m3s, corresponding to a wet film growth rate of 1 µm/s. Finally, the nFOG technique is demonstrated by preparing polymer films with thicknesses in the range of approximately 0.1–20 µm. |
| Note de contenu : |
- EXPERIMENTAL METHODS AND MATERIALS : nFOG coating system - Aerosol droplet size determination - Droplet deposition measurements - Film coating and characterization
- RESULTS AND DISCUSSION : Droplet size distribution in the aerosol - Droplet mass flux onto the substrate - Deposition mechanism of the droplets - Polymer film coatings |
| DOI : |
10.1007/s11998-017-0022-7 |
| En ligne : |
https://link.springer.com/content/pdf/10.1007%2Fs11998-017-0022-7.pdf |
| Format de la ressource électronique : |
Pdf |
| Permalink : |
https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=30758 |
in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH > Vol. 15, N° 3 (05/2018) . - p. 623-632
[article]
|
Aller sur edunet
Accueil
Ajouter le résultat dans votre panier Affiner la rechercheAérosols : un nouveau solvant, le méthylal in PARFUMS COSMETIQUES AROMES, N° 113 (11/93)
