Titre : |
Software helps reduce time to market for fibre-reinforced plastic control arm |
Type de document : |
texte imprimé |
Auteurs : |
Fabio Pulina, Auteur ; Olivier Lietaer, Auteur |
Année de publication : |
2019 |
Article en page(s) : |
p. 25-27 |
Langues : |
Anglais (eng) |
Catégories : |
Bras de commande Composites à fibres courtes Composites à fibres de verre Composites à fibres de verre -- Moulage par injection Distribution et orientation des fibres Logiciels Matériaux -- Allègement PolyamidesUn polyamide est un polymère contenant des fonctions amides -C(=O)-NH- résultant d'une réaction de polycondensation entre les fonctions acide carboxylique et amine.
Selon la composition de leur chaîne squelettique, les polyamides sont classés en aliphatiques, semi-aromatiques et aromatiques. Selon le type d'unités répétitives, les polyamides peuvent être des homopolymères ou des copolymères. Simulation par ordinateur
|
Index. décimale : |
668.4 Plastiques, vinyles |
Résumé : |
Magneti Marelli's Suspension Systems group was tasked with redesigning a steel control arm into injection-moulded fibre-reinforced plastics to reduce weight and improve fuel economy. The subject matter of this metal replacement project was a steel control arm belonging to the B-SUV segment ; so its loads, and its design space have been considered. The compagny's engineers selected a polyamide fibre resin with short glass fibre reinforcements because this material is a good fit for the control arm's primary mechanical requirements, which are strength and endurance. |
Note de contenu : |
- Different design configurations
- Determining material properties with different fibre orientations
- Simulating the injection moulding process to determine local fibre orientation
- Anisotropic simulation achieved by coupling Digimat-RP and Abaqus FEA software
- Fig. 1 : The failure point predicted by a homogeneous isotropic simulation for a conditioned reinforced plastic part with bushings did not match the physical testing
- Fig. 2 : Evaluating the effects of fibre orientation on material properties
- Fig. 3 : Determining fibre location and orientation in the moulded part
- Fig. 4 and 5 Workflow for the coupled simulation |
Permalink : |
https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=31783 |
in JEC COMPOSITES MAGAZINE > N° 126 (01-02/2019) . - p. 25-27