Accueil
Catégories
Ajouter le résultat dans votre panier Affiner la recherche
Etendre la recherche sur niveau(x) vers le bas
Effect of sputtering parameters on the self-cleaning properties of amorphous titanium dioxide thin films in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH, Vol. 14, N° 6 (11/2017)
[article]
Titre : Effect of sputtering parameters on the self-cleaning properties of amorphous titanium dioxide thin films Type de document : texte imprimé Année de publication : 2017 Article en page(s) : p. 1423-1433 Note générale : Bibliogr. Langues : Américain (ame) Catégories : Couches minces
Dioxyde de titane
Hydrophilie
Magnétron
Matériaux amorphes
Photocatalyse
Pulvérisation
Revêtement auto-nettoyantIndex. décimale : 667.9 Revêtements et enduits Résumé : The aim of this work was to assess the effect of the direct current magnetron sputtering parameters on the photocatalytic activity and photoinduced wettability of amorphous TiO2 films. TiO2 films were deposited on glass using the direct current magnetron sputtering technique, without heating, at different total working pressures. Qualitative analysis using in situ X-ray photoelectron spectroscopy confirmed the TiO2 stoichiometry of the deposited films. Surface structure was studied as a function of working pressure using scanning electron microscopy. The hydrophilicity of the TiO2 surfaces was investigated macroscopically using measurements of the water contact angle. A threshold working pressure was observed, with a strong dependence on the film thickness. A super hydrophilic surface was observed after less than 1 h of UV irradiation. The photocatalytic activity of the films was evaluated under UV light through the degradation of methylene blue (λmax≈660nm). The effect of UV irradiation on the photocatalytic activity was rapid, strong, and dependent on film thickness and total working pressure. Fifty percent of organic compounds were photodegraded by films with a thickness of 60 nm deposited at 10 mTorr. Note de contenu : - EXPERIMENTAL DETAILS : Sample preparation - Contact angle measurements - Photocatalytic tests - X-ray photoelectron spectroscopic analysis - Characterization
- RESULTS AND DISCUSSION : TiO2 film deposition - Structural characterization - Photoinduced superhydrophilicity - Photocatalytic activityDOI : 10.1007/s11998-017-9928-3 En ligne : https://link.springer.com/content/pdf/10.1007%2Fs11998-017-9928-3.pdf Format de la ressource électronique : Permalink : https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=29654
in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH > Vol. 14, N° 6 (11/2017) . - p. 1423-1433[article]Réservation
Réserver ce document
Exemplaires (1)
Code-barres Cote Support Localisation Section Disponibilité 19441 - Périodique Bibliothèque principale Documentaires Disponible Investigation of the adhesion of NbN coatings deposited by pulsed dc reactive magnetron sputtering using scratch tests / Yasar Totik in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH, Vol. 7, N° 4 (07/2010)
[article]
Titre : Investigation of the adhesion of NbN coatings deposited by pulsed dc reactive magnetron sputtering using scratch tests Type de document : texte imprimé Auteurs : Yasar Totik, Auteur Année de publication : 2010 Article en page(s) : p.485-492 Note générale : Bibliogr. Langues : Américain (ame) Catégories : Adhésion
Essais de résilience
Magnétron
Pulvérisation cathodique
Revêtements:PeintureTags : Revêtement 'Nitrure de niobium' Adhésion 'Test au choc' 'Pulvérisation par magnétron' 'Testeur progressif zéro charge' PLST 'Microscopie électronique balayage' SEM patch multi-test' MPST Index. décimale : 667.9 Revêtements et enduits Résumé : Scratch tests have been used to investigate the adhesion of niobium nitride (NbN) coatings that were deposited by pulsed dc reactive magnetron sputtering at target currents of 1.5, 2.5, and 3.5 A onto M2 tool steel and silicon wafer. The coating adhesion on each material substrate was investigated using a progressive load scratch tester (PLST) and a multi-pass scratch tester (MPST). Microhardness tests and scanning electron microscopy (SEM) were also used to examine the hardness and microstructure of the NbN coatings. These results have indicated that the structural, mechanical, and adhesion properties of the NbN coatings improve with increasing target currents. While performing PLST and MPST tests, the highest adhesion and lowest friction force were obtained for the coatings deposited at a target current of 3.5 A. In addition, the triboscobic behaviors that were observed from the MPST of the coatings indicated that the target currents affect the friction behavior of the coatings. DOI : 10.1007/s11998-009-9200-6 En ligne : https://link.springer.com/content/pdf/10.1007%2Fs11998-009-9200-6.pdf Format de la ressource électronique : Permalink : https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=9771
in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH > Vol. 7, N° 4 (07/2010) . - p.485-492[article]Réservation
Réserver ce document
Exemplaires (1)
Code-barres Cote Support Localisation Section Disponibilité 012362 - Périodique Bibliothèque principale Documentaires Disponible Microstructure and mechanical properties of hafnium carbide coatings synthesized by reactive magnetron sputtering / Li Guanqun in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH, Vol. 7, N° 3 (05/2010)
[article]
Titre : Microstructure and mechanical properties of hafnium carbide coatings synthesized by reactive magnetron sputtering Type de document : texte imprimé Auteurs : Li Guanqun, Auteur ; Geyang Li, Auteur Année de publication : 2010 Article en page(s) : p. 403-407 Note générale : Bibliogr. Langues : Américain (ame) Catégories : Carbure d'hafnium
Magnétron
Microstructures
Pulvérisation cathodique
Revêtements:PeintureIndex. décimale : 667.9 Revêtements et enduits Résumé : Hafnium carbide coatings with different carbon contents were synthesized in Ar–C2H2 mixture by reactive magnetron sputtering. Energy-dispersive X-ray, X-ray diffraction, scanning electron microscopy, atomic force microscopy, and nanoindentation were employed to characterize their microstructure and mechanical properties. The effects of C2H2 partial pressure on the composition, phase, microstructure, and mechanical properties of the coatings were investigated. The results show that hafnium carbide coatings can be synthesized at a low partial pressure of C2H2. The single-phase HfC coating with columnar crystal and favorable mechanical properties is obtained when the proportion of C2H2 partial pressure is only about 3.0% in the mixture, and the highest hardness and modulus are 27.9 and 255 GPa, respectively. The coating contains metal Hf and HfC phases and obtains low hardness under lower C2H2 partial pressure. When the C2H2 partial pressure is higher, the hardness and elastic moduli of acquired amorphous coatings decrease significantly. DOI : 10.1007/s11998-009-9225-x En ligne : https://link.springer.com/content/pdf/10.1007%2Fs11998-009-9225-x.pdf Format de la ressource électronique : Permalink : https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=9820
in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH > Vol. 7, N° 3 (05/2010) . - p. 403-407[article]Réservation
Réserver ce document
Exemplaires (1)
Code-barres Cote Support Localisation Section Disponibilité 012381 - Périodique Bibliothèque principale Documentaires Disponible Nanocrystalline γ-Al2O3 thin film deposited by magnetron sputtering (MS) at low temperature / Adele Carradò in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH, Vol. 7, N° 4 (07/2010)
Réservation
Réserver ce document
Exemplaires (1)
Code-barres Cote Support Localisation Section Disponibilité 012362 - Périodique Bibliothèque principale Documentaires Disponible Physical properties of Al-doped ZnO films deposited on nonwoven substrates by radio frequence magnetron sputtering / Bingyao Deng in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH, Vol. 5, N° 3 (09/2008)
[article]
Titre : Physical properties of Al-doped ZnO films deposited on nonwoven substrates by radio frequence magnetron sputtering Type de document : texte imprimé Auteurs : Bingyao Deng, Auteur ; Qufu Wei, Auteur ; Weidong Gao, Auteur Année de publication : 2008 Article en page(s) : p. 393-397 Note générale : Bibliogr. Langues : Américain (ame) Catégories : Absorption
AluminiumL'aluminium est un élément chimique, de symbole Al et de numéro atomique 13. C’est un métal pauvre, malléable, de couleur argent, qui est remarquable pour sa résistance à l’oxydation13 et sa faible densité. C'est le métal le plus abondant de l'écorce terrestre et le troisième élément le plus abondant après l'oxygène et le silicium ; il représente en moyenne 8 % de la masse des matériaux de la surface solide de notre planète. L'aluminium est trop réactif pour exister à l'état natif dans le milieu naturel : on le trouve au contraire sous forme combinée dans plus de 270 minéraux différents, son minerai principal étant la bauxite, où il est présent sous forme d’oxyde hydraté dont on extrait l’alumine. Il peut aussi être extrait de la néphéline, de la leucite, de la sillimanite, de l'andalousite et de la muscovite.
L'aluminium métallique est très oxydable, mais est immédiatement passivé par une fine couche d'alumine Al2O3 imperméable de quelques micromètres d'épaisseur qui protège la masse métallique de la corrosion. On parle de protection cinétique, par opposition à une protection thermodynamique, car l’aluminium reste en tout état de cause très sensible à l'oxydation. Cette résistance à la corrosion et sa remarquable légèreté en ont fait un matériau très utilisé industriellement.
L'aluminium est un produit industriel important, sous forme pure ou alliée, notamment dans l'aéronautique, les transports et la construction. Sa nature réactive en fait également un catalyseur et un additif dans l'industrie chimique ; il est ainsi utilisé pour accroître la puissance explosive du nitrate d'ammonium.
Dépôt par pulvérisation
Lumière visible
Magnétron
Microscopie à force atomique
Nontissés
Oxyde de zinc
Polyéthylène téréphtalate
Spectrophotométrie UV-Visible
TransmittanceLa transmittance, en général, est le rapport caractérisant la transmission d'une grandeur dans un système. Elle se calcule par le rapport entre la grandeur en entrée et en sortie.
En optique, la transmittance d'un matériau ou d'un filtre est la fraction du flux lumineux le traversant. Elle est également nommée facteur de transmission mais aussi transparence dans le domaine de la photographie.Index. décimale : 667.9 Revêtements et enduits Résumé : In this study, the polyethylene terephthalate (PET) spunbonded nonwoven materials were used as substrates for creating electro-optical functional nanostructures on the fiber surfaces. A magnetron sputter coating was used to deposit Al-doped ZnO (AZO) films onto the nonwovens. The influences of the deposition time on the structural, optical, and electrical properties of AZO films were investigated. Atomic force microscopy (AFM) was employed to examine the topography of the fibers. The AFM observation revealed a significant difference in the morphology of the fibers before and after the AZO sputter coating. The examination by UV–visible spectrophotometer analysis showed that the nonwovens deposited with transparent nanostructure AZO films had better UV absorption, and an average transmittance was approximately 50% in the visible light wavelength region. The surface conductivity of the materials was analyzed using a four-probe meter, and it was found that electrical resistance was significantly decreased as the sputtering time increased. DOI : 10.1007/s11998-008-9087-7 En ligne : https://link.springer.com/content/pdf/10.1007%2Fs11998-008-9087-7.pdf Format de la ressource électronique : Permalink : https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=2983
in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH > Vol. 5, N° 3 (09/2008) . - p. 393-397[article]Réservation
Réserver ce document
Exemplaires (1)
Code-barres Cote Support Localisation Section Disponibilité 010633 - Périodique Bibliothèque principale Documentaires Disponible Structural and mechanical investigations of magnetron sputtering TiO2/Ti/TiN multilayer films on Si(100) substrate / Adele Carradò in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH, Vol. 7, N° 6 (11/2010)
PermalinkStructures and properties of the polyester nonwovens coated with titanium dioxide by reactive sputtering / Yang Xu in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH, Vol. 7, N° 5 (09/2010)
Permalink