Accueil
Catégories
Ajouter le résultat dans votre panier Affiner la recherche
Etendre la recherche sur niveau(x) vers le bas
Coating of hydrophilic poly(hydroxypropyl methacrylate) thin films via pulsed-initiated chemical vapor deposition method / Emine Sevgili Mercan in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH, Vol. 18, N° 5 (09/2021)
[article]
Titre : Coating of hydrophilic poly(hydroxypropyl methacrylate) thin films via pulsed-initiated chemical vapor deposition method Type de document : texte imprimé Auteurs : Emine Sevgili Mercan, Auteur ; Mustafa Karaman, Auteur Année de publication : 2021 Article en page(s) : p. 1261-1268 Note générale : Bibliogr. Langues : Américain (ame) Catégories : Caractérisation
Dépôt chimique en phase vapeur
Hydrophilie
Polyméthacrylate d'hydroxypropyle
Revêtements organiquesIndex. décimale : 667.9 Revêtements et enduits Résumé : This study demonstrates the coating of poly(hydroxypropyl methacrylate) (PHPMA) thin films from the corresponding monomer HPMA using pulsed-initiated chemical vapor deposition (pulsed-iCVD) method. The advantages of pulsing the power delivered to the filament wires during iCVD through successive on–off duty cycles (DC) are outlined by considering the deposition rates, structure, and morphology of as-deposited PHPMA films. FTIR and XPS analysis of the as-deposited films verifies that pulsing the filament power produces thin films of PHPMA, which is structurally very similar to that synthesized using classical continuous power iCVD. However, there is up to 70% increase in deposition rate upon pulsing the filament power in comparison with the continuous power iCVD. AFM analysis of the as-deposited films shows that the film morphology can be controlled by varying the DC during pulsed-iCVD. At a DC of 85.7%, the most hydrophilic film is observed with a measured water contact angle of 31°. Note de contenu : - EXPERIMENTAL : Materials - Pulsed iCVD of PHPMA thin films - Characterization of the as-deposited thin films
- RESULTS AND DISCUSSION : Deposition kinetics - Structure and morphology of as-deposited films
- Table 1: Experimental conditions
- Table 2 : Average (Tavrg) and minimum (Tmin) filament temperature values in different duty cycle percentages (FRHPMA=0.5 sccm, FRTBPO=1 sccm, Ts=30°C, P=170 mtorr)
DOI : https://doi.org/10.1007/s11998-021-00486-w En ligne : https://link.springer.com/content/pdf/10.1007/s11998-021-00486-w.pdf Format de la ressource électronique : Permalink : https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=36430
in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH > Vol. 18, N° 5 (09/2021) . - p. 1261-1268[article]Réservation
Réserver ce document
Exemplaires (1)
Code-barres Cote Support Localisation Section Disponibilité 22991 - Périodique Bibliothèque principale Documentaires Disponible