Modeling and estimation of the pressure and temperature dependent bulk density of polymers / Christian Kneidinger in INTERNATIONAL POLYMER PROCESSING, Vol. XXXV, N° 1 (03/2020)  

[article]  inINTERNATIONAL POLYMER PROCESSING > Vol. XXXV, N° 1 (03/2020) . - p. 70-82 Titre : Modeling and estimation of the pressure and temperature dependent bulk density of polymers Type de document : texte imprimé Auteurs : Christian Kneidinger, Auteur ; M. Längauer, Auteur ; Gernot Zitzenbacher, Auteur ; S. Schuschnigg, Auteur ; Jürgen Miethlinger, Auteur Année de publication : 2020 Article en page(s) : p. 70-82 Note générale : Bibliogr. Langues : Anglais (eng) Catégories : Extrudeuse monovis Masse volumique Mesure Modèles mathématiques Polymères Pression Index. décimale : 668.4 Plastiques, vinyles Résumé : The bulk density of polymers is a crucial factor for the throughput and the pressure build-up of single screw plasticating units. It depends not only on the density of the polymeric material itself, but also on the geometry of the single pellets, on the dimensions of the screw channel and, furthermore, on the temperature and the pressure. A review of the existing models shows that there is potential for improvement, as their applicability is restricted. It is difficult to obtain model parameters, as they can only be determined by experiment, but there are only a few devices which enable temperature- and pressure-dependent bulk density to be measured. Furthermore, these devices are not standardized. This work presents a new model which can be used to calculate the bulk density as a function of pressure and temperature and an adapted approach that considers the dimensions of the single pellets and the screw channel. The model is verified by both, new data derived from experiments and data from the literature. Compared to existing models, this new model fits the experimental data better, requires fewer parameters and shows much better extrapolation behavior as well as a continuous changeover behavior at the melting temperature. Another big advantage of the new model compared to the existing ones is that the model parameters of this new model can be estimated from the stress at yield and from the melting temperature. This enables a rough estimation of the pressure and temperature dependent bulk density without having to measure it. Note de contenu : - INTRODUCTION : Measurement of the bulk density - Existing models - Evaluation of the existing models - PROPOSED MODEL : Material density - Adjustable approach - Simplified approach - Combined approach - Modification by implementation of the volumetric transition temperature - Modifications considering the temperature dependence of the bulk density at zero pressure - Consideration of the screw channel geometry - Benefits of the new model compared to the existing models - Parameter fitting - MATERIALS USED - RESULTS AND DISCUSSION - ESTIMATING MODEL PARAMETERS FROM MATERIAL PROPERTIES DOI : https://doi.org/10.3139/217.3876 En ligne : https://drive.google.com/file/d/1jH3kB_e72-_OymLxouI82g5CYVTN2VzK/view?usp=drive [...] Format de la ressource électronique : Pdf Permalink : https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=33780 [article]

Réservation

Réserver ce document

Exemplaires (1)

Code-barres	Cote	Support	Localisation	Section	Disponibilité
21578	-	Périodique	Bibliothèque principale	Documentaires	Disponible

---

1 (1 - 1 / 1)