Hydrophobization, smoothing, and barrier improvements of cellulose nanofibril films by sol–gel coatings / Jari Vartiainen in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH, Vol. 17, N° 1 (01/2020)  

[article]  inJOURNAL OF COATINGS TECHNOLOGY AND RESEARCH > Vol. 17, N° 1 (01/2020) . - p. 305-314 Titre : Hydrophobization, smoothing, and barrier improvements of cellulose nanofibril films by sol–gel coatings Type de document : texte imprimé Auteurs : Jari Vartiainen, Auteur ; Klaus Rose, Auteur ; Yukihiro Kusano, Auteur ; Juha Mannila, Auteur ; Lisa Wikström, Auteur Année de publication : 2020 Article en page(s) : p. 305-314 Note générale : Bibliogr. Langues : Américain (ame) Catégories : Angle de contact Brillance (optique) Cellulose La cellulose est un glucide constitué d'une chaîne linéaire de molécules de D-Glucose (entre 200 et 14 000) et principal constituant des végétaux et en particulier de la paroi de leurs cellules. Copolymères Couches minces Hydrophobie Matériaux -- Propriétés barrières Matières plastiques -- Revêtement Microscopie électronique à balayage Nanofibres Rugosité Sol-gel, Procédé Index. décimale : 667.9 Revêtements et enduits Résumé : Single-layer films from cellulose nanofibrils on a plastic support were coated with sol–gel coated with inorganic–organic copolymers (ORMOCER®s), consisting of inorganic Si–O–Si-based networks combined with ceramic (Al–O– and Zr–O–) groups and special organic fluoroalkyl chain containing functional groups. Sol–gel coatings decreased the surface hydrophilicity and water vapor transmission rate. The water contact angle of uncoated films was 24°, indicating high affinity between water and the cellulose nanofibrils. All sol–gel coatings tested increased the surface hydrophobicity with the contact angles ranging between 54° and 102°. The water vapor transmission rates varied between 230 and 410 g/m2/day. With UV curable highly organically crosslinked coating, the water vapor transmission rate was decreased by 77% as compared to uncoated film. The uncoated film had oxygen transmission rates of 0.7 and 107 cc/m2/day at 50% and 80% RH, respectively. At high humidity conditions, the films tended to swell, thus allowing permeation to increase. Sol–gel coatings significantly improved the oxygen barrier properties especially at 80% RH. The transmission rates varied between 0.4 and 0.5 cc/m2/day (50% RH) and between 51 and 86 cc/m2/day (80% RH). Note de contenu : - Cellulose nanofibrils (CNF) and CNF films - Sol-gel coatings - Scanning electron microscopy (SEM) - Roughness - Gloss - Contact angle measurements - Oxygen permeation - Water vapor permeation DOI : 10.1007/s11998-019-00292-5 En ligne : https://link.springer.com/content/pdf/10.1007/s11998-019-00292-5.pdf Format de la ressource électronique : Pdf Permalink : https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=33747 [article]

Réservation

Réserver ce document

Exemplaires (1)

Code-barres	Cote	Support	Localisation	Section	Disponibilité
21517	-	Périodique	Bibliothèque principale	Documentaires	Disponible

Surface hydrophobization of CNF films by roll-to-roll HMDSO plasma deposition / Jari Vartiainen in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH, Vol. 13, N° 6 (11/2016)  

[article]  inJOURNAL OF COATINGS TECHNOLOGY AND RESEARCH > Vol. 13, N° 6 (11/2016) . - p. 1145-1149 Titre : Surface hydrophobization of CNF films by roll-to-roll HMDSO plasma deposition Type de document : texte imprimé Auteurs : Jari Vartiainen, Auteur ; Tero Malm, Auteur Année de publication : 2016 Article en page(s) : p. 1145-1149 Note générale : Bibliogr. Langues : Américain (ame) Catégories : Cellulose La cellulose est un glucide constitué d'une chaîne linéaire de molécules de D-Glucose (entre 200 et 14 000) et principal constituant des végétaux et en particulier de la paroi de leurs cellules. Hydrophobie Matériaux -- Propriétés barrières Nanofibres Projection au plasma Revêtements:Peinture Silylation La silylation est l'introduction d'un groupe silyle, généralement substitué (R3Si–), dans une molécule. Surfaces (technologie) Index. décimale : 667.9 Revêtements et enduits Résumé : Cellulosic films are typically sensitive towards moisture which limits their industrial applicability. In this study the films made from cellulose nanofibrils (CNF) were surface silylated with hexamethyldisiloxane (HMDSO) by roll-to-roll plasma deposition. The effects on surface hydrophobicity were clear and indisputable. Water contact angles of non-modified and plasma-deposited CNF films were 23° and 103°, respectively. As a result of surface silylation the relative polarity decreased from 46.8% to 0.6%. Surface hydrophobicity correlated well with the plasma deposition line speeds (0.5, 5, and 10 m/min) and the water vapor barrier properties. Silylation also decreased the oxygen transmission rates both at 50% and 80% relative humidity as compared to non-modified CNF films. All films were completely impermeable to olive oil and intact in contact with castor oil, toluene, and n-heptane or mixtures of them. The developed surface hydrophobization method can be exploited in strengthening the position of cellulosic films in high performance film applications. DOI : 10.1007/s11998-016-9833-1 En ligne : http://link.springer.com/content/pdf/10.1007%2Fs11998-016-9833-1.pdf Format de la ressource électronique : Pdf Permalink : https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=27276 [article]

Réservation

Réserver ce document

Exemplaires (1)

Code-barres	Cote	Support	Localisation	Section	Disponibilité
18514	-	Périodique	Bibliothèque principale	Documentaires	Disponible

---

1 (1 - 2 / 2)