[article]
Titre : |
Saving on drying time |
Type de document : |
texte imprimé |
Auteurs : |
Johan Nienhuis, Auteur ; Mari de Meijer, Auteur |
Année de publication : |
2002 |
Article en page(s) : |
p. 29-30 |
Langues : |
Anglais (eng) |
Catégories : |
Bois -- Revêtements protecteurs Revêtement -- Séchage:Peinture -- Séchage Revêtements en phase aqueuse:Peinture en phase aqueuse
|
Index. décimale : |
667.9 Revêtements et enduits |
Résumé : |
In the first part of an article on waterborne coatings for the wood industry the authors report on why a chain approach is needed from joinery industry to the building site.
Stricter legislation on the use of solvent borne coatings forces the Dutch joinery industry to consider alternative primer systems. A logical choice is to switch to waterborne primers. However, if these coatings are used in the typical DUtch way of building, then problems may arise.
The method of construction of houses in The Netherlands starts by putting up window frames and subsequently building brick walls around them. Therefore, during the construction phase, the primed wood is exposed to moisture (rain), cement and damages. Attention must, therefore, be paid to the performance of a waterborne coating in the first months after application.
It is known that waterborne coatings improve their performance after a longer drying time, but this may be critical if the film formation process has not been fully completed. |
Note de contenu : |
- Evaluation studies
- Chain gangs
- Legislation and emissions
- Better drying facilities
- Pigments affect drying |
Permalink : |
https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=28039 |
in POLYMERS PAINT COLOUR JOURNAL - PPCJ > Vol. 192, N° 4455 (08/2002) . - p. 29-30
[article]
|