Titre : |
Rheological studies of the cure of epoxy/powder coatings containing titanium dioxide |
Type de document : |
texte imprimé |
Auteurs : |
Emile C. Trottier, Auteur ; Stanley Affrossman, Auteur ; Richard A. Pethrick, Auteur |
Année de publication : |
2012 |
Article en page(s) : |
p. 725-733 |
Note générale : |
Bibliogr. |
Langues : |
Américain (ame) |
Catégories : |
Dioxyde de titane Epoxydes Oxyde de zinc Polyesters Réticulation (polymérisation) Revêtements poudre:Peinture poudre Rhéologie Rhéomètres SiliceLa silice est la forme naturelle du dioxyde de silicium (SiO2) qui entre dans la composition de nombreux minéraux.
La silice existe à l'état libre sous différentes formes cristallines ou amorphes et à l'état combiné dans les silicates, les groupes SiO2 étant alors liés à d'autres atomes (Al : Aluminium, Fe : Fer, Mg : Magnésium, Ca : Calcium, Na : Sodium, K : Potassium...).
Les silicates sont les constituants principaux du manteau et de l'écorce terrestre. La silice libre est également très abondante dans la nature, sous forme de quartz, de calcédoine et de terre de diatomée. La silice représente 60,6 % de la masse de la croûte terrestre continentale.
|
Index. décimale : |
667.9 Revêtements et enduits |
Résumé : |
The cure characteristics of a series of powder coatings containing titanium dioxide dispersed in an epoxy/polyester matrix are reported. The titanium dioxide pigments were produced via both the chloride and sulfate routes and coated with varying amounts of alumina and silica. Comparison data for formulations containing zinc oxide and silica are also included. The time to gelation for these powder coatings depends on a number of factors. Increasing the level of flow agent significantly reduces the time to gelation. The presence of traces of zinc inhibits cure in the case of the sulfate-based pigments. Varying levels of alumina and silica in the coating on the titanium dioxide coating also influence the time to gelation. Increasing the level of silica on the chloride-based coating increases the time to gelation, whereas in the case of the sulfate based coating the time to gelation is shortened. These differences are attributed to the effects of zinc in the coating and the effectiveness of the dicyandiamide catalysts. |
Note de contenu : |
- MATERIALS : Titanium dioxide pigments - Surface area - Surface acidity - Other pigments - Resins - Formulation of powder coating
- RHEOLOGICAL MEASUREMENTS : Effect of Modaflow on the cure process - Effect of TiO2 grade on the cure process - Effect of zinc oxide on the cure behavior - Effects of silica on the cure behavior - Effect of TiO2 loading on cure behavior |
DOI : |
10.1007/s11998-012-9417-7 |
En ligne : |
https://link.springer.com/content/pdf/10.1007%2Fs11998-012-9417-7.pdf |
Format de la ressource électronique : |
Pdf |
Permalink : |
https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=16658 |
in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH > Vol. 9, N° 6 (11/2012) . - p. 725-733