Accueil
Catégories
Ajouter le résultat dans votre panier Affiner la recherche
Etendre la recherche sur niveau(x) vers le bas
Using LCA to select coatings for optimum environmental and cost performance / Nick J. Hazel in JOURNAL OF COATINGS TECHNOLOGY (JCT), Vol. 68, N° 861 (10/1996)
[article]
Titre : Using LCA to select coatings for optimum environmental and cost performance Type de document : texte imprimé Auteurs : Nick J. Hazel, Auteur Année de publication : 1996 Article en page(s) : p. 117-121 Note générale : Bibliogr. Langues : Américain (ame) Catégories : Coût de production
Durée de vie (Ingénierie)
Environnement -- Protection
Pollution -- Lutte contre
RevêtementsIndex. décimale : 667.9 Revêtements et enduits Résumé : Coating systems are very complex and LCA studies require careful setting up. Definition of the functional unit in terms of articles or coated area, with statements on performance (including durability) is necessary.
- A system approach is preferred, which takes account of multiple coats, and pre and post treatments (e.g., in service replacement/repair).
- A fair basis for comparison is needed for a credible study, attention must be given to data quality issues.
- Emissions are best grouped according to major contributory cause (sub-system/process).
- Where trade-offs are identified, emission control options are difficult to justify and need to be approached with caution.
- Steps taken to reduce certain emissions will not increase others, E.g., containment ; these changes are easy to justify.
- Environmental burdens from high-solids and wtaer based coatings tend to converge as solids levels increase, differences become less significant.
- Cost benefit analysis indicates that high solids systems should be seen as an end-point technology, not as a stop-gap.Note de contenu : - INTRODUCTION : Performance - Economics - Environmental
- LIFE CYCLE ASSESSMENT (LCA) : Methodology
- SCOPE : Systems - Dta sources and quality
- BASIS FOR COMPARISONS : Functional unit - Performance matching - State of the art
- ANALYSIS : Environmentally based performance criteria - Environmental convergencePermalink : https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=18448
in JOURNAL OF COATINGS TECHNOLOGY (JCT) > Vol. 68, N° 861 (10/1996) . - p. 117-121[article]Réservation
Réserver ce document
Exemplaires (2)
Code-barres Cote Support Localisation Section Disponibilité 003519 - Périodique Bibliothèque principale Documentaires Disponible 003530 - Périodique Bibliothèque principale Documentaires Exclu du prêt Volatile methylsiloxanes as exempt solvents in protective coatings / William A. Finzel in JOURNAL OF COATINGS TECHNOLOGY (JCT), Vol. 68, N° 852 (01/1996)
[article]
Titre : Volatile methylsiloxanes as exempt solvents in protective coatings Type de document : texte imprimé Auteurs : William A. Finzel, Auteur Année de publication : 1996 Article en page(s) : p. 69-72 Note générale : Bibliogr. Langues : Américain (ame) Catégories : Composés organiques volatils
Environnement -- Protection
Formulation (Génie chimique)
Haut extrait sec
Revêtements protecteurs
SiloxanesLes siloxanes sont une classe de composés du silicium dont la formule empirique est R2SiO, où R est un groupe radical qui peut être organique. Des exemples représentatifs sont [SiO(CH3)2]n (diméthylsiloxane) et [SiO(C6H5)2]n (diphénylsiloxane), où n est typiquement supérieur à 4. Ces composés peuvent être des hybrides organiques et inorganiques. Les chaînes organiques confèrent au composé des propriétés hydrophobes alors que la chaîne principale -Si-O-Si-O- est purement inorganique.
Le mot siloxane est dérivé de Silicium, Oxygène et alkane.
Des siloxanes peuvent être trouvés dans des produits tels que des cosmétiques, des déodorants, des enduits hydrophobes pour pare-brise, des peintures et certains savons.
Les siloxanes polymérisés (polysiloxanes) sont appelés silicones1,2.
Le siloxane est massivement utilisé dans l'industrie cosmétique (rouges à lèvre, conditionneurs et shampooings, déodorants, etc.).
Une application récente du Siloxane D5 (2001) a été trouvée dans le nettoyage à sec des textiles en remplacement du perchloroéthylène. Ce procédé est très répandu aux États-Unis et au Royaume-Uni. Il devient de plus en plus courant en Europe continentale dont la France, afin de promouvoir l'usage de procédés écologiques et respectueux de la santé humaine.
Solvants organiquesIndex. décimale : 667.9 Revêtements et enduits Résumé : Volatile methylsiloxanes, which were excluded from the definition of VOC by the EPA in late 1994, can now be considered alternative solvents for protective coatings. The decision by the EPA was based on research concluding that these products did not contribute to ground-level ozone formation.
Both linear and cyclic volatile methylsiloxanes (VMS) have low solvency when tested with silicone resins and should be classified as diluents. When added to selected silicone resins containing strong solvents, the VMS fluids either reduce viscosity with little change in VOC content or reduce VOC content by acting as a partial replacement with strong solvents.
Two specific products - octamethyltrisiloxane (L-3) and octamethyltetrasiloxane (C-4) - were chosen as representative linear and cyclic VMS products. VOC content was reduced in three different paint systems using two VMS products. Two paint systems were sprayed on steel substrates and did not show any evidence of wetting problems.
Based on solubility and cost, the cyclic product octamethylcyclotetrasiloxane is the VMS product of choice and should be considered when there is a need to reduce VOC content of solvent-based paint systems.Note de contenu : - VOLATILE METHYLSILOXANES
- SOLUBILITY
- VOC DETERMINATION
- HIGH-SOLIDS PAINT SYSTEMS : Aluminum paints - Black paint - Silicone alkyd gray paintPermalink : https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=18312
in JOURNAL OF COATINGS TECHNOLOGY (JCT) > Vol. 68, N° 852 (01/1996) . - p. 69-72[article]Réservation
Réserver ce document
Exemplaires (2)
Code-barres Cote Support Localisation Section Disponibilité 003513 - Périodique Bibliothèque principale Documentaires Disponible 003522 - Périodique Bibliothèque principale Documentaires Exclu du prêt A waterborne and environmentally benign, marine timber coating / Brian G. Dixon in JOURNAL OF COATINGS TECHNOLOGY (JCT), Vol. 66, N° 837 (10/1994)
[article]
Titre : A waterborne and environmentally benign, marine timber coating Type de document : texte imprimé Auteurs : Brian G. Dixon, Auteur ; Wendy Gomes, Auteur Année de publication : 1994 Article en page(s) : p. 21-25 Note générale : Bibliogr. Langues : Américain (ame) Catégories : Amines Une amine est un composé organique dérivé de l'ammoniac dont certains hydrogènes ont été remplacés par un groupement carboné. Si l'un des carbones liés à l'atome d'azote fait partie d'un groupement carbonyle, la molécule appartient à la famille des amides. Découvertes en 1849, par Wurtz les amines furent initialement appelées alcaloïdes artificiels.
On parle d'amine primaire, secondaire ou tertiaire selon que l'on a un, deux ou trois hydrogènes substitués.
Par exemple, la triméthylamine est une amine tertiaire, de formule N(CH3)3.
Typiquement, les amines sont obtenues par alkylation d'amines de rang inférieur. En alkylant l'ammoniac, on obtient des amines primaires, qui peuvent être alkylées en amines secondaires puis amines tertiaires. L'alkylation de ces dernières permet d'obtenir des sels d'ammonium quaternaire.
D'autre méthodes existent : 1. Les amines primaires peuvent être obtenues par réduction d'un groupement azoture, 2. Les amines peuvent aussi être obtenues par la réduction d'un amide, à l'aide d'un hydrure, 3. L'amination réductrice permet l'obtention d'amines substituées à partir de composés carbonylés (aldéhydes ou cétones), 4. Les amines primaires peuvent être obtenues par la réaction de Gabriel.
Animaux marins
Bois -- Revêtements protecteurs
Environnement -- Protection
Epoxydes
Formulation (Génie chimique)
Marines (peinture)
Pollution -- Lutte contre
Réticulants
Revêtements antisalissures
Revêtements en phase aqueuse:Peinture en phase aqueuseIndex. décimale : 667.9 Revêtements et enduits Résumé : A novel waterborne coating system, which has significantly advanced the state of the art for protecting wooden structures from the ravages of marine borers, as well as fouling organisms in general, is discussed. The use of an innovative primer layer between the wood's surface and an overlaying protective polymer layer has imparted significantly improved resistance of coated wood samples to attack by wood boring organisms. The proposed technology is also attractive since it involves only environmentally compatible components and is easy to apply. Note de contenu : - RESEARCH OBJECTIVES
- EXPERIMENTAL : Wood, chitosan, and glutaraldehyde solutions - Epoxy formulations - Coating physical properties - Analytical
- RESULTS AND DISCUSSION : Wooden substrates, chitosan, and glutaraldehyde films - Epoxy formulations made using the amine curing agent - Waterborne epoxy formulations - Filled coatings - Ocean test protocol and biofouling resultsPermalink : https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=18718
in JOURNAL OF COATINGS TECHNOLOGY (JCT) > Vol. 66, N° 837 (10/1994) . - p. 21-25[article]Réservation
Réserver ce document
Exemplaires (2)
Code-barres Cote Support Localisation Section Disponibilité 003471 - Périodique Bibliothèque principale Documentaires Disponible 003484 - Périodique Bibliothèque principale Documentaires Exclu du prêt