Accueil
Catégories
Ajouter le résultat dans votre panier Affiner la recherche
Etendre la recherche sur niveau(x) vers le bas
Split-hopkinson pressure bar test and numerical simulation of steel fiber-reinforced high-strength / Ji Li in REVUE DES COMPOSITES ET DES MATERIAUX AVANCES, Vol. 29, N° 2 (04/2019)
[article]
Titre : Split-hopkinson pressure bar test and numerical simulation of steel fiber-reinforced high-strength Type de document : texte imprimé Auteurs : Ji Li, Auteur ; Shaoqing Shi, Auteur ; Qiulin He, Auteur ; Shou Chen, Auteur Année de publication : 2019 Article en page(s) : p. 109-117 Note générale : Bibliogr. Langues : Français (fre) Catégories : Béton renforcé de fibres
Contraintes (mécanique)
Essais de résilience
Essais dynamiques
Fibres d'acier
Impact (mécanique)
Simulation par ordinateurRésumé : The fabrication and optimization of the shelter layer are critical to the performance of the protective works. The novel shelter layer made of steel fiber-reinforced high-strength concrete (SFRHSC) is much more advantageous than that of ordinary concrete. This paper curies out a split-Hopkinson pressure bar (SHPB) test on the steel fiber and high-strength concrete, two main components of the SFRHSC, aiming to disclose the failure features and dynamic compressive strength of the SFRHSC under dynamic conditions. Specifically, the SFRHSC specimens with 0 %, 0.5 % and 1.0 % of steel fiber were subjected to impact compression test under the air pressures of 0.7, 0.9 and 1. OMPa, respectively. In addition, the impact compression process was also numerically simulated on the finite-element software LS-DYNA. The research results show that : the increase in strain rate pushed up the dynamic compressive strength of the SFRHSC, that is, the failure degree of the specimen was greatly enhanced by the strain rate; under the air pressure of 0.7MPa, the specimen with 1.0 % of steel fiber had the highest dynamic compressive strength (1 80.9MPa), 22.6 % higher than that of the specimen with no steel fiber; the numerical simulation reproduced the one-dimensional (ID) propagation of the stress wave in the bars, which proves the hypothesis of ID elastic stress wave, and restaged the impact compression process on the SFRHSC, outputting results similar to the test data. Note de contenu : - TEST OVERVIEW
- TEST PRINCIPLE
- ERROR ANALYSIS : Interface friction effect - Stress wave dispersion effect
- TEST PROCEDURE
- NUMERICAL SIMULATION
- ANALYSIS ON SHPB TEST RESULTS : Comparison of test phenomena - Energy absorption of the SFRHSC - Analysis on dynamic response data
- ANALYSIS ON NUMERICAL SIMULATION RESULTSDOI : https://doi.org/10.18280/rcma.290206 En ligne : https://www.iieta.org/download/file/fid/12198 Format de la ressource électronique : Permalink : https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=34800
in REVUE DES COMPOSITES ET DES MATERIAUX AVANCES > Vol. 29, N° 2 (04/2019) . - p. 109-117[article]Réservation
Réserver ce document
Exemplaires (1)
Code-barres Cote Support Localisation Section Disponibilité 22405 - Périodique Bibliothèque principale Documentaires Disponible