Accueil
Catégories
Ajouter le résultat dans votre panier Affiner la recherche
Etendre la recherche sur niveau(x) vers le bas
Why must the process control make corrections on restart ? / Stefan Kruppa in KUNSTSTOFFE INTERNATIONAL, Vol. 107, N° 9 (09/2017)
[article]
Titre : Why must the process control make corrections on restart ? : Part 3 of the series "More stability in injection molding with APC plus" Type de document : texte imprimé Auteurs : Stefan Kruppa, Auteur Année de publication : 2017 Article en page(s) : p. 33-34 Langues : Anglais (eng) Catégories : Commande de processus
Matières plastiques -- Moulage par injection
Procédés de fabricationIndex. décimale : 668.4 Plastiques, vinyles Résumé : In injection molding, repeated interruptions are a familiar problem. The aim is rapid restart without rejects and production loss. This challenge is met by the APC plus machine function from KraussMaffei. Note de contenu : - Fig 1. Without APC plus, significantfluctuations in the part quality can be seen after a material exchange and restart (top). With ACP plus (bottom) these fluctuations can be noticeably compensated. The side view of the part can be seen at the top right hand side of the picture
- Fig. 2. On manual start-up(left), the changeover point is reduced to a low level and returned to the target value in five shots. On start-up with APC plus activated (right), the changeover point is only reduced as far as necessary ; the number of defective parts is reduced from 5 to 1En ligne : https://drive.google.com/file/d/12NxbRVl5h_f3YwrYYGvqi-pOgzjcuRNe/view?usp=drive [...] Format de la ressource électronique : Permalink : https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=29103
in KUNSTSTOFFE INTERNATIONAL > Vol. 107, N° 9 (09/2017) . - p. 33-34[article]Réservation
Réserver ce document
Exemplaires (1)
Code-barres Cote Support Localisation Section Disponibilité 19135 - Périodique Bibliothèque principale Documentaires Disponible