| Titre : |
Process-integrated surface modification during injection molding |
| Type de document : |
texte imprimé |
| Auteurs : |
Thomas Härtig, Auteur ; Michael Gehde ; Jürgen Nagel, Auteur |
| Année de publication : |
2010 |
| Article en page(s) : |
p. 31-35 |
| Note générale : |
Bibliogr. |
| Langues : |
Anglais (eng) |
| Index. décimale : |
668.4 Plastiques, vinyles |
| Résumé : |
Material bonding - The one-time introduction of energy to melt a plastic resin can be used to also initiate chemical reactions. This permits bonding of an ultra-thin layer of a functional polymer to the surface of the molded part. In this way, process-integrated surface modification during injection molding becomes possible. |
| Note de contenu : |
- Thin modifier film on the mold's surface
- The challenge : achieving high yields
- Permanent modification demonstrated in actual practice
- Adhesion during two-component injection molding
- Pattern-based selective surface modification |
| Permalink : |
https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=8124 |
in KUNSTSTOFFE INTERNATIONAL > Vol. 100, N° 1/2010 (01/2010) . - p. 31-35
Aller sur edunet
Accueil
Process-integrated surface modification during injection molding in KUNSTSTOFFE INTERNATIONAL, Vol. 100, N° 1/2010 (01/2010)
