| Titre : |
Why measure permeability ? |
| Type de document : |
texte imprimé |
| Auteurs : |
Jérôme Raynal, Auteur ; Aurélien Philippe, Auteur |
| Année de publication : |
2015 |
| Article en page(s) : |
p. 75-76 |
| Langues : |
Anglais (eng) |
| Catégories : |
Composites à fibres -- Moulage par injection
Essais (technologie)
Mesure
Moulage par transfert de résine sous vide
Perméabilité
|
| Index. décimale : |
668.4 Plastiques, vinyles |
| Résumé : |
Permeability is one of a reinforcement's intrinsic properties that must be controlled during the manufacture of a part made of a composite material. This property can be illustrated as the average cross section of the microchannels where the resin flows during reinforcement impregnation in liquid composite moulding [LCM) technologies such as RTM. |
| Note de contenu : |
- Easyperm, the 3D permeability test bench
- In-Plane (X,Y) measurement with Easyperm
- Through-plane (Z) permeability measurement
- Correlation of measurements : comparing Easyperm's measured values with those simulated with PAM-RTM
- Advantages and benefits
- FIGURES : Longitudinal, radial and 3D injection - 2. The Easyperm 3D permeability test bench is based on a patented measurement concept with X, Y and Z axes
- 3. Mould shown in X, Y configuration - 4. Pressure change in the case of Kx, Ky measurement - 5. Mould shown in Z configuration - 6. Pressure changes in the case of a Kz measurement |
| Permalink : |
https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=25933 |
in JEC COMPOSITES MAGAZINE > N° 100 (10/2015) . - p. 75-76
Aller sur edunet
Accueil
Why measure permeability ? in JEC COMPOSITES MAGAZINE, N° 100 (10/2015)
