| Titre : |
Simulation of injection molding using a model with delayed fiber orientation |
| Type de document : |
texte imprimé |
| Auteurs : |
G. M. Vélez-Garcia, Auteur ; S. M. Mazahir, Auteur ; P. Wapperom, Auteur ; D. G. Baird, Auteur |
| Année de publication : |
2011 |
| Article en page(s) : |
p. 331-339 |
| Note générale : |
Bibliogr. |
| Langues : |
Anglais (eng) |
| Catégories : |
Distribution et orientation des fibres
Folgar-Tucker, Modèle de
Matières plastiques -- Moulage par injection
Polybutylène téréphtalate
Simulation par ordinateur
|
| Index. décimale : |
668.4 Plastiques, vinyles |
| Résumé : |
Delay in fiber orientation evolution based on the Folgar-Tucker model with a slip parameter correction has been proposed as a simple alternative to improve predictions of fiber orientation in injection molded parts. Predictions based on this model and model parameters fitted to data from simple shear experiments were compared with experimentally determined fiber orientation in a center-gated disk. Three methods of fitting to simple shear data were assessed to obtain the isotropic diffusivity and the slip parameter. The model parameters and orientation data evaluated at the entry, lubrication and near-end-of fill regions in a center-gated disk for 30 wt.% short glass fiber-filled polybutylene terephtalate (PBT) were obtained from earlier efforts in our laboratory. Simulation results based on the Folgar-Tucker model with the slip correction using customarily assumed inlet orientation being random and experimentally measured at the gate disagreed with measured orientation values at certain positions along the disk. However, improvement in the prediction of orientation due the slip correction was found at the core and transition layers in the lubrication region. The use of inlet conditions washes out quickly in the absence of the slip correction and induced a general reduction of orientation towards the center of the sample causing underestimation of orientation at the entry and lubrication region. Model predictions combining the slip correction and experimentally determined orientation at the gate are in agreement with the experimental data for the core layers near the end-of-fill region. |
| DOI : |
10.3139/217.2478 |
| En ligne : |
https://drive.google.com/file/d/1PMZ_KHs6ntFIU93AYhpLbGdgsr8lJ5TS/view?usp=drive [...] |
| Format de la ressource électronique : |
Pdf |
| Permalink : |
https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=12422 |
in INTERNATIONAL POLYMER PROCESSING > Vol. XXVI, N° 3 (07/2011) . - p. 331-339
Aller sur edunet
Accueil
Simulation of injection molding using a model with delayed fiber orientation in INTERNATIONAL POLYMER PROCESSING, Vol. XXVI, N° 3 (07/2011)
