The effects of some engraving and film substrate parameters on the solid density and the dot gain in gravure printing / E. N. Gencoglu in SURFACE COATINGS INTERNATIONAL. PART B : COATINGS TRANSACTIONS, Vol. 88, B1 (03/2005)  

[article]  inSURFACE COATINGS INTERNATIONAL. PART B : COATINGS TRANSACTIONS > Vol. 88, B1 (03/2005) . - p. 19-23 Titre : The effects of some engraving and film substrate parameters on the solid density and the dot gain in gravure printing Type de document : texte imprimé Auteurs : E. N. Gencoglu, Auteur Année de publication : 2005 Article en page(s) : p. 19-23 Note générale : Bibliogr. Langues : Anglais (eng) Catégories : Angle de contact Encre Héliogravure Masse volumique Polyesters Polypropylène Rugosité Structure biaxiale Tension superficielle Index. décimale : 667.9 Revêtements et enduits Résumé : The effects of some engraving and film substrate parameters on the solid density and dot gain in gravure printing were studied by using polyester, BOPP plain film and BOPP co-extruded film substrates. Bi-axially oriented polypropylene (BOPP) is a product utilised in numerous industries such as food packaging, printing, laminating and labeling. It was concluded that the solid density of print is affected by the roughness values of the film substrates. Increasing the roughness value increases the print density. The number of cells per cm2 and the depth of the cells also affect the solid density. Deeper and fewer cells per cm2 give a lower solid density value than shallower cells and more cells per cm2. Engraving parameters have a major effect on the dot gain. The channel between cells has a positive effect on the dot gain. The cell depth and the number of cells per cm2 also affect the dot gain. The highest dot gain value was measured from the 35% coverage area of all of the scales printed on all the substrates. Also, the highest dot gain values were measured for the prints on polyester the smoothest substrate. Note de contenu : - EXPERIMENTAL METHODS : Printing substrates - Surface tention and water contact angle - Surface roughness - RESULTS AND DISCUSSION : Solid density - Effect of engraving parameters - Dot gain - Table 1 : Engraving properties of printed scales - Table 2 : Properties of printing substrates DOI : 10.1007/BF02699703 En ligne : https://link.springer.com/content/pdf/10.1007/BF02699703.pdf Format de la ressource électronique : Pdf Permalink : https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=5432 [article]

Réservation

Réserver ce document

Exemplaires (1)

Code-barres	Cote	Support	Localisation	Section	Disponibilité
000389	-	Périodique	Bibliothèque principale	Documentaires	Disponible

---

1 (1 - 1 / 1)