Titre : |
Specimen site and number of skins required to represent selected physical properties of ovine garment leather |
Type de document : |
texte imprimé |
Auteurs : |
S. Lange, Auteur ; B. E. Niven, Auteur ; R. M. Laing, Auteur |
Année de publication : |
2000 |
Article en page(s) : |
p. 127-131 |
Note générale : |
Bibliogr. |
Langues : |
Anglais (eng) |
Catégories : |
Cuirs et peaux -- Propriétés physiques Cuirs et peaux de moutons Echantillonnage
|
Index. décimale : |
675 Technologie du cuir et de la fourrure |
Résumé : |
Properties critical in the manufacture of garments from textile materials were measured on 158 ovine skins typical of those used in garment manufacture, and the location from which properties of leather most represent those of the whole skin identified. Mass, thickness, compression, bending and extension under low loads (lOOgf/cm) were measured at between four and eight locations either side of the spine, and two directions (0 and 90° to the spine) on each skin. The most representative location was adjacent to the spine and in the middle of the skin, and was similar to but larger than that recommended in existing standard test methods for leather. Approximately 10 skins were required to estimate the properties of a batch of ovine garment leather. |
Note de contenu : |
- METHODS : Estimated sample size required for skins with similar variability - Sample size
- RESULTS AND DISCUSSION : Identifying the location most representative of properties of a skin : Sample size
- Table 1 : Number of skins to be selected for measurement
- Table 2 : Identifying the location most representative of properties of a skin
- Table 3 : Estimated sample size required for skins with similar variability |
En ligne : |
https://drive.google.com/file/d/1ZjPHKkxUg20UeglnnzAgnrk_-gGZjmcO/view?usp=drive [...] |
Format de la ressource électronique : |
Pdf |
Permalink : |
https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=41234 |
in JOURNAL OF THE SOCIETY OF LEATHER TECHNOLOGISTS & CHEMISTS (JSLTC) > Vol. 84, N° 3 (05-06/2000) . - p. 127-131