[article]
Titre : |
Methods for studying the mechanical and tribological properties of hard and soft coatings with a nano-indenter |
Type de document : |
texte imprimé |
Auteurs : |
Weidian C. Shen, Auteur ; Frank N. Jones, Auteur ; Paul D. Ziemer, Auteur ; J. David Nordstrom, Auteur ; Wenjing Mao, Auteur ; Zhiqiang Liu, Auteur ; Jian Sun, Auteur |
Année de publication : |
2004 |
Article en page(s) : |
p. 117-125 |
Note générale : |
Bibliogr. |
Langues : |
Américain (ame) |
Catégories : |
Dureté (matériaux) Indentation des matériaux Latex Polyacryliques Résistance à l'abrasion Revêtements -- Propriétés mécaniques:Peinture -- Propriétés mécaniques ThermoplastiquesUne matière thermoplastique désigne une matière qui se ramollit (parfois on observe une fusion franche) d'une façon répétée lorsqu'elle est chauffée au-dessus d'une certaine température, mais qui, au-dessous, redevient dure. Une telle matière conservera donc toujours de manière réversible sa thermoplasticité initiale. Cette qualité rend le matériau thermoplastique potentiellement recyclable (après broyage). Cela implique que la matière ramollie ne soit pas thermiquement dégradée et que les contraintes mécaniques de cisaillement introduites par un procédé de mise en forme ne modifient pas la structure moléculaire.
|
Index. décimale : |
667.9 Revêtements et enduits |
Résumé : |
This study illustrates the capabilities of a nanoindentation/nanoscratch tester to assess mechanical and tribological properties of coating films. Properties such as hardness, elastic modulus, mar and scratch resistance, and critical force for cracking can be accurately measured. Operation of the Nano-Indenter is described in detail. A scanning probe microscope (SPM) is shown to be a valuable supplement to the Nano-Indenter. Well-characterized thermoset acrylic clearcoats and thermoplastic latex films were studied. For the first time, operating parameters are described for measurement of relatively soft coatings, such as films cast from a latex with a glass transition temperature (Tg) of 8°C. Thus, the method is made available for study of most types of coatings. The method can easily discriminate between coatings with different Tgs and crosslink densities. Once operating parameters are established, it takes about 10 minutes for an indentation test and 10 minutes for a scratch test with the Nano-Indenter, and with further automation this time could be reduced. Each indtntation test accurately measures hardness and elastic modulus as a function of depth within the coating, and each scratch test provides additional insight into the material's behavior. The method is sensitive to small changes in polymer composition and formulation, and results are highly reproducible. |
DOI : |
10.1007/s11998-004-0006-2 |
En ligne : |
https://link.springer.com/content/pdf/10.1007%2Fs11998-004-0006-2.pdf |
Format de la ressource électronique : |
Pdf |
Permalink : |
https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=3957 |
in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH > Vol. 1, N° 2 (04/2004) . - p. 117-125
[article]
|