| Résumé : |
For almost two decades, it has been known that the addition of colorants to a waterborne latex coating thickened with an associative thickener will result in a viscosity loss. The influence of surfactants on viscosity variations in waterborne latex coatings, as discussed in our most recent fCT COATINGSTECH article, is the source of the viscosity decreases. To evaluate this problem, aqueous solutions containing large quantities of five different surfactants, and the smallest particle size of the colorants, carbon black (CB), were prepared. Large quantities of surfactant were used to allow for adsorption on, and stabilization of, CB. When traditional associative polymers (HMHEC, HASE, and a telechelic HEUR) were used to thicken carbon black dispersions, viscosity decreases were not observed, for most of the surfactant is adsorbed on the CB's surface. There is enough surfactant, however, to promote viscosity decreases in comb-HEUR thickened CB dispersions. Moving beyond the colorant dispersions, the CB, yellow, or red colorants were then added to a commercial latex paint that contains many surfactants, glycol ether, and coalescing aids, and significant viscosity decreases were observed. The decreases were very dramatic as the colorant concentration was increased to obtain deeper color tones, due to the additional excess surfactant added to the coating. Reduction in total surfactant levels in the colorant was an obvious solution, but this led to rub-up incompatibility. The conflict between viscosity retention and rub-up incompatibility was resolved when the surfactant concentration was reduced by adding to the colorant formulation compositionally different hydrophobically-modified poly(oxyethylenes) and hydrophobe-modified maleic acid co-oligomers. |
Aller sur edunet
Accueil
Waterborne latex coatings of color : I. Component influences on viscosity decreases in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH, Vol. 2, N° 8 (10/2005)
