| Titre : |
Delamination of coating from a ship's hull |
| Type de document : |
texte imprimé |
| Auteurs : |
Cheryl Roberts, Auteur |
| Année de publication : |
2018 |
| Article en page(s) : |
p. 9-12 |
| Langues : |
Anglais (eng) |
| Catégories : |
Analyse des défaillances (fiabilité)
Bateaux -- Revêtements:Bateaux -- Peinture
Chimie analytique
Coques (architecture navale)
Délaminage
Revêtements protecteurs -- Détérioration
|
| Index. décimale : |
667.9 Revêtements et enduits |
| Résumé : |
Unlike many industrial strucures, ships often contain a variety of multi-layer coating systems on a single vessel, and even on the exterior hull itself, often including a complex sequence of anticorrosive layers followed by antifouling layers. This article focuses on the recoating of ship's exterior hull that resulted in catastrophic failure before the ship was ever returned to service. |
| Note de contenu : |
- THE BACKGROUND
- FIELD INVESTIGATION
- LABORATORY INVESTIGATION : Microscopic Examination - Solvent Rub Test - Nitrogen Analysis : Mix Ratio - Recoat Interval Study - Tackiness/Tack-Free Test - Batch Composition Testing - Amine Exudate Analysis
Fig. 1 : An illustration of the hull of the ship with the deep-load line (DDL), light-load line (LLL) and specifications for the coating systems applied.
Fig. 2 : Lower, middle and upper sampling sites. The black area is the boot top
Fig. 3 : Cross section of a paint chip obtained from within 1^(-1/2) feet above the DLL showing the extra red layer sandwiched between the gray layers at 200-times magnification
Fig. 4 : Variations of adhesion with length of time between application of red AF and gray AC coating
Tab. 1 : Results of Tack-Free Study |
| Permalink : |
https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=31583 |
in JOURNAL OF PROTECTIVE COATINGS & LININGS (JPCL) > Vol. 35, N° 6 (06/2018) . - p. 9-12
Aller sur edunet
Accueil
Delamination of coating from a ship's hull in JOURNAL OF PROTECTIVE COATINGS & LININGS (JPCL), Vol. 35, N° 6 (06/2018)
