Titre : |
Comparative study of the dynamic hydrophobicity of fluoroalkylsilane coatings tilted at acute and obtuse angles |
Type de document : |
texte imprimé |
Auteurs : |
Yuta Higashino, Auteur ; Hirokazu Takahashi, Auteur ; Munetoshi Sakai ; Toshihiro Isobe ; Sachiko Matsushita, Auteur ; Akira Nakajima, Auteur |
Année de publication : |
2018 |
Article en page(s) : |
p. 891-898 |
Note générale : |
Bibliogr. |
Langues : |
Américain (ame) |
Catégories : |
Angle de glissement Fluoroalkylsilane Gouttelettes Hydrophobie Revêtements organiques
|
Index. décimale : |
667.9 Revêtements et enduits |
Résumé : |
The relation between surface homogeneity and internal fluidity for a droplet sliding on a surface tilted at acute and obtuse angles was investigated using two hydrophobic fluoroalkylsilane (FAS) coatings with different roughness. The coatings (FAS-smooth and FAS-rough) were prepared on an Si substrate using chemical vapor deposition or soaking methods and were tilted at 35° or 145°. Sliding velocity of water droplets on the surface tilted at 145° was greater than that tilted at 35° for both coatings. For 35° tilting, the dominant mode of the sliding velocity was slipping for FAS-smooth, whereas rolling governed the entire sliding velocity for FAS-rough. The slipping mode was more important than the rolling one for both coatings when they were tilted at 145°. The change of slipping velocity was more remarkable than that of rolling one for both coatings between 35° and 145° tilting. Results show that the difference in gravity direction and contact area of the droplets contributed to this tilt angle dependence of the sliding velocity. When a droplet slid down with acceleration on FAS-smooth surface, the coefficient of the viscous drag force correlated with the velocity ratio (Utotal/Uslip). |
DOI : |
10.1007/s11998-018-0064-5 |
En ligne : |
https://link.springer.com/content/pdf/10.1007%2Fs11998-018-0064-5.pdf |
Format de la ressource électronique : |
Pdf |
Permalink : |
https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=30866 |
in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH > Vol. 15, N° 4 (07/2018) . - p. 891-898