| Titre : |
Liquid film coating of small molecule OLEDs |
| Type de document : |
texte imprimé |
| Auteurs : |
Katharina Peters, Auteur ; Lukas Wengeler, Auteur ; Philip Scharfer, Auteur ; Wilhelm Schabel, Auteur |
| Année de publication : |
2014 |
| Article en page(s) : |
p. 75-81 |
| Note générale : |
Bibliogr. |
| Langues : |
Américain (ame) |
| Catégories : |
Démouillage (chimie des surfaces)
Diodes électroluminescentes
Enduction par filière
Lame d'enduction
Molécules
Revêtements
Tension superficielle
Viscosité
|
| Index. décimale : |
667.9 Revêtements et enduits |
| Résumé : |
Organic small molecules typically deposited by vacuum deposition are a promising material for efficient, low-cost, area light-emitting diodes (OLEDs). In this article we discuss methods to apply these materials by solvent-based large area coating methods. As a basis for the technical description of the coating and wetting process, we present material properties, such as viscosity and surface tension of SMOLED solutions and polar and disperse part for the surface energy of typical substrates or semiconducting organic layers. Whereas SM content has little effect on the ink properties, impurities were identified as an important factor for the wetting behavior. Based on the material properties and coating experiments with SMOLED solutions, the coating methods of blade and slot die coating are discussed with respect to film thickness and stability. We found that the film thickness of knife-coated films does depend on velocity, temperature, provided fluid volume, and composition. Calibration curves for commercial materials (NMP and Spiro-MeOTAD) are given. The stability of slot die coating was lower than expected from literature. However, homogeneous SMOLED layers could be produced by slot die coating at gap-to-film-thickness ratios of up to 50. |
| Note de contenu : |
- EXPERIMENTAL : Materials - Methods
- MATERIALS PROPERTIES
- LIQUID FILM COATING OF SMALL MOLECULE SINGLE LAYERS : Self-metering method : knife coating - Pre-metered method : slot die coating |
| DOI : |
10.1007/s11998-013-9515-1 |
| En ligne : |
https://link.springer.com/content/pdf/10.1007%2Fs11998-013-9515-1.pdf |
| Format de la ressource électronique : |
Pdf |
| Permalink : |
https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=20618 |
in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH > Vol. 11, N° 1 (01/2014) . - p. 75-81
Aller sur edunet
Accueil
Ajouter le résultat dans votre panier Affiner la rechercheLiquid film coating of small molecule OLEDs / Katharina Peters in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH, Vol. 11, N° 1 (01/2014)
