[article]
| Titre : |
Process limits in two-layer reverse roll transfer |
| Type de document : |
texte imprimé |
| Auteurs : |
M. Sasaki, Auteur ; W. J. Suszynski, Auteur ; M. S. Carvalho, Auteur ; Lorraine F. Francis, Auteur |
| Année de publication : |
2013 |
| Article en page(s) : |
p. 485-492 |
| Note générale : |
Bibliogr. |
| Langues : |
Américain (ame) |
| Catégories : |
Défauts
Enduction au rouleau
Revêtements multicouches
|
| Index. décimale : |
667.9 Revêtements et enduits |
| Résumé : |
Reverse roll coating in which a thin single layer of liquid is applied onto a substrate has been used in industry for decades and has been extensively analyzed in the literature. Modern coatings, however, are often composed of more than one layer to improve the product performance and to reduce the manufacturing cost. Premetered methods such as slot, slide, and curtain coatings are typically used to produce such multilayer coatings. If the caliper of the substrate to be coated is not constant, then the coating gap and consequently the final film thickness deposited on the web will also be nonuniform. In this study, we focused on the use of reverse roll technique with slot die liquid delivery system to produce a uniform thin two-layer coating. The use of this coating technique to produce such a coating has not been previously explored. The liquid film surface as it is transferred from a rigid steel roll to a deformable urethane-covered roll was visualized to find out how the uniformity of the two-layer coating is affected by the speed ratio between two rolls, layers’ wet thicknesses, and liquid viscosities. The effect of these parameters on the ribbing frequency and amplitude was also investigated. The results show that in the two-layer coating, as in the single layer reverse transfer, there is a critical web speed above which ribbing occurs. The critical speed is determined by the bottom layer viscosity. |
| DOI : |
10.1007/s11998-012-9444-4 |
| En ligne : |
https://link.springer.com/content/pdf/10.1007%2Fs11998-012-9444-4.pdf |
| Format de la ressource électronique : |
Pdf |
| Permalink : |
https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=19098 |
in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH > Vol. 10, N° 4 (07/2013) . - p. 485-492
[article]
|
Aller sur edunet
Accueil
Process limits in two-layer reverse roll transfer in JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH, Vol. 10, N° 4 (07/2013)
