| Titre : |
Profile die design based on flow balancing : Balancing with flow separation |
| Type de document : |
texte imprimé |
| Auteurs : |
P. Saha, Auteur ; J. Å vábÃk, Auteur |
| Année de publication : |
1999 |
| Article en page(s) : |
p. 247-253 |
| Note générale : |
Bibliogr. |
| Langues : |
Anglais (eng) |
| Index. décimale : |
668.9 Polymères |
| Résumé : |
This paper presents a methodology for the design of profile dies based on the Cross Flow Minimization Method. The flow balancing is described for cases where the flows are balanced by varying the die land length combined with the flow separation. Three different approaches were utilized in the die analysis. First, the flow in two proposed profile dies was calculated by substituting the flow domain by a set of simple geometries. The second approach applied the Cross-Sectional Calculation method, while the last method is a fully 3D FEM non-isothermal calculation. The results are verified by comparison with experimental data. It is shown that each of the calculation procedures may be the choice of preference depending on the geometrical complexity. |
| Note de contenu : |
- INTRODUCTION : Flow balancing methods - Numerical procedures
- CASE STUDY : Material properties - Profile shape requirements
- EXPERIMENTAL : Die design considerations - Simple geometries (SG) calculation - Cross sectional (CS) calculation - Fully 3D FEM - Comparison of the three calculation methods - Experimental data |
| DOI : |
10.3139/217.1550 |
| En ligne : |
https://drive.google.com/file/d/1A12K6OpOtsQsyMAfZVMlwCOcqIlDpVp9/view?usp=drive [...] |
| Format de la ressource électronique : |
Pdf |
| Permalink : |
https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=16135 |
in INTERNATIONAL POLYMER PROCESSING > Vol. XIV, N° 3 (09/1999) . - p. 247-253
Aller sur edunet
Accueil
Profile die design based on flow balancing in INTERNATIONAL POLYMER PROCESSING, Vol. XIV, N° 3 (09/1999)
