[article]
| Titre : |
Evaluation of a model describing the advancing flow front in injection moulding |
| Type de document : |
texte imprimé |
| Auteurs : |
F. Pisciotti, Auteur ; A. Boldizar, Auteur ; M. Rigdahl, Auteur ; G. Aronsson, Auteur ; M. Rigdahl |
| Année de publication : |
2002 |
| Article en page(s) : |
p. 133-145 |
| Note générale : |
Bibliogr. |
| Langues : |
Anglais (eng) |
| Index. décimale : |
668.9 Polymères |
| Résumé : |
The simulation of the advancing flow front during mould filling in the injection moulding cycle is important as a way of anticipating manufacturing defects, particularly different types of welds, air traps, cold spots and hot spots. The purpose of the present work was to evaluate a model (the distance model) simulating the advancing flow front and predicting potential issues related to the progression of the flow front such as welds and air traps. The distance model is based on a mathematical theory of Hele-Shaw flow for strongly shear-thinning fluids, i. e. fluids with a power-law index, n, equal to 0,3 or preferably less. Two grades of general-purpose polystyrene were selected according to their abilities to shear thin (weakly or moderately strong) at the selected processing temperature and in the typical shear rate range of the injection moulding process. The two grades were injection moulded into twelve mould configurations derived from two similar single-gated moulds. The flow length from the gate to the weld was measured in the mouldings obtained at three distinct rates of filling (conventional, slower and faster) and compared to the flow lengths obtained by the distance model. Good agreement was found between the predicted flow lengths and the experimental flow lengths at the conventional and faster filling conditions. Larger deviations between simulation and experiment were found at the slower filling rate, particularly for the weakly shear-thinning polystyrene grade. Some comparisons were also made with the predictions obtained using the commercial simulation code Moldflow. A comparison between the advancing front predictions of the distance model and experimental short shots of a commercial polypropylene grade in a lure-box type of mould geometry showed that the distance model, despite its simplicity, could probably be used to detect welds and air traps in more complex and practice-related mouldings. |
| Note de contenu : |
- INTRODUCTION : Manufacturing defects related to mould filling - The distance model -
- EXPERIMENTAL : Materials - Mould geometry - Processing - Flow length measurement
- RESULTS AND DISCUSSION : Weld detection - The advancing flow front - A practice-related moulding |
| DOI : |
10.3139/217.1682 |
| En ligne : |
https://drive.google.com/file/d/15mW8TQTMJGeBpUZ0EWylo9zGHAYQhFm4/view?usp=drive [...] |
| Format de la ressource électronique : |
Pdf |
| Permalink : |
https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=15942 |
in INTERNATIONAL POLYMER PROCESSING > Vol. XVII, N° 2 (06/2002) . - p. 133-145
[article]
|
Aller sur edunet
Accueil
Evaluation of a model describing the advancing flow front in injection moulding in INTERNATIONAL POLYMER PROCESSING, Vol. XVII, N° 2 (06/2002)
