Experimental and theoretical study on screw filling in starve fed single screw extruders / Krzysztof J. Wilczynski in INTERNATIONAL POLYMER PROCESSING, Vol. XXXIII, N° 2 (05/2018)  

[article]  inINTERNATIONAL POLYMER PROCESSING > Vol. XXXIII, N° 2 (05/2018) . - p. 171-179 Titre : Experimental and theoretical study on screw filling in starve fed single screw extruders Type de document : texte imprimé Auteurs : Krzysztof J. Wilczynski, Auteur Année de publication : 2018 Article en page(s) : p. 171-179 Note générale : Bibliogr. Langues : Anglais (eng) Catégories : Extrudeuse monovis Facteur de remplissage (technologie) Matières plastiques -- Extrusion Polyéthylène basse densité Polyéthylène haute densité Polymères -- Fusion Pression Température Index. décimale : 668.4 Plastiques, vinyles Résumé : An extensive experimental and theoretical study has been performed on screw filling in starve fed/flood fed single screw extruders. The effect of screw speed, flow rate (level of starvation) and die geometry has been investigated. A “screw pulling-out” technique was used in the study. The solid conveying, melting positions, the extent of starvation, and the fully filled regions were observed. It was seen that filling of the screw increases with an increase of the flow rate at a fixed screw speed, and decreases with an increase of the screw speed at a fixed flow rate. The screw filling is strongly dependent on the die geometry and increases with an increase of the resistance of the die. The pressure was also measured, and it was observed that it considerably decreases with starvation. Mechanism of screw filling has been discussed. The simulations and experiments were performed for low density polyethylene (LDPE) and high density polyethylene (HDPE) at various operating conditions, both for starve fed and flood fed extrusion. Fill factor, pressure, temperature and melting profiles have been computed and validated experimentally. All the experimental observations were consistent with the simulations. Note de contenu : - Starve feeding vs. flood feeding - Simulations - Experimental validation of process simulation DOI : 10.3139/217.3386 En ligne : https://drive.google.com/file/d/1TFYZRY4IEBnZzYZJHwYR73VM1CoOIZyQ/view?usp=drive [...] Format de la ressource électronique : Pdf Permalink : https://e-campus.itech.fr/pmb/opac_css/index.php?lvl=notice_display&id=30565 [article]

Réservation

Réserver ce document

Exemplaires (1)

Code-barres	Cote	Support	Localisation	Section	Disponibilité
19873	-	Périodique	Bibliothèque principale	Documentaires	Disponible

---

1 (1 - 1 / 1)